1) Wood Bead Bracelet
Supplies:
8mm Flat Wood Beads
11/0 Gold E-beads
Stretchy Cord
Jewelry Glue (optional)
INSTRUCTIONS
1. Cut cord to about 12" and knot 2 inches from end.
2. Prestretch cord.
3. Thread on a wood bead, then E-bead. Repeat until desired length is achieved.
4. Knot ends and apply a dot of jewelry glue over knot.
2) Wood Bead Earrings
Supplies:
8mm Flat Wood Beads
11/0 Gold E-beads
Earring Findings
Headpins, Gold
4mm Jump Rings
Round-Nose Pliers
Long-Nose Pliers
INSTRUCTIONS
1. Thread on beads to headpins as shown in picture
2. Create a loop at top of head pin. (See fig. 1-3). Cut excess wire.
3. Open up jump ring and attach dangle and earring. Close jump ring tightly.
Design by Darlene Dishion - Project courtesy of Darice.com
Printer-friendly version:
